Rotational Equilibrium and Newton's First Law in Rotational Form MCQ Practice

Question 1 of 10

A rigid wheel rotates at constant angular velocity about a fixed axis. What must be true?

  1. A. Every external torque individually is zero.
  2. B. The wheel is at rest.
  3. C. The net external torque about that axis is zero.
  4. D. Every external force is zero.

Question 2 of 10

A light seesaw has a 300 N load 2 m left of the pivot. Where must a 200 N load be placed on the right for rotational equilibrium?

  1. A. 1.33 m from the pivot
  2. B. 2 m from the pivot
  3. C. 6 m from the pivot
  4. D. 3 m from the pivot

Question 3 of 10

A stationary uniform horizontal beam of weight W is supported at its two ends by upward forces. There are no other loads. What is each support force?

  1. A. W/2
  2. B. W
  3. C. 2W
  4. D. Zero

Question 4 of 10

A rotor experiences torques of 5 N m clockwise and 5 N m counterclockwise. It initially rotates clockwise. What happens if these remain the only torques?

  1. A. It accelerates counterclockwise.
  2. B. It continues at constant clockwise angular velocity.
  3. C. It immediately stops.
  4. D. It accelerates clockwise.

Question 5 of 10

A rigid body has zero net external force but nonzero net external torque about its center of mass. Which is possible?

  1. A. Both velocities must be constant
  2. B. The body must be at rest
  3. C. Constant center-of-mass velocity with changing angular velocity
  4. D. Changing center-of-mass velocity with constant angular velocity

Question 6 of 10

A uniform horizontal beam is held at rest by a left hinge and a cable at its right end. The cable angle above horizontal is reduced while the beam stays horizontal. How must the cable tension change?

  1. A. It must decrease.
  2. B. It must remain the same.
  3. C. It becomes zero.
  4. D. It must increase.

Question 7 of 10

Two nonzero torques on a rigid body have equal magnitudes. What else is needed for rotational equilibrium?

  1. A. They must tend to turn it in opposite senses.
  2. B. They must act at the same location.
  3. C. The body must already be at rest.
  4. D. Their forces must have equal magnitudes.

Question 8 of 10

A beam is in static equilibrium. Why is it often useful to take torques about a hinge?

  1. A. Only horizontal forces can produce torque.
  2. B. The unknown hinge forces have zero lever arm about that axis.
  3. C. Gravity then exerts no torque about any axis.
  4. D. The hinge forces become zero.

Question 9 of 10

A wheel coasts at constant angular velocity about a vertical axle with ideal frictionless bearings. A student adds a constant downward force exactly along that axle. Which statement about rotational equilibrium is justified?

  1. A. The added force stops rotation because it points downward.
  2. B. The wheel must accelerate clockwise.
  3. C. The added force produces no axle torque, so it does not disturb rotational equilibrium.
  4. D. Any added force necessarily changes angular velocity.

Question 10 of 10

A rigid object maintains constant angular velocity while its center of mass accelerates. Which condition describes this motion?

  1. A. Translational equilibrium without rotational equilibrium
  2. B. Both types of equilibrium
  3. C. Neither type of equilibrium
  4. D. Rotational equilibrium without translational equilibrium