Torque and Work MCQ Practice

Question 1 of 10

A constant clockwise torque of magnitude 2 N m acts while a wheel turns clockwise through 3 rad. What work does the torque do?

  1. A. +6 J
  2. B. -6 J
  3. C. 0 J
  4. D. +1.5 J

Question 2 of 10

A rotor makes two complete revolutions while a constant driving torque of 1.5 N m acts in its direction of motion. What is the work?

  1. A. $12\pi$ J
  2. B. $6\pi$ J
  3. C. $3\pi$ J
  4. D. 3 J

Question 3 of 10

A rotating wheel has sufficient initial energy to turn continuously in the positive sense. The graph shows net torque versus angular position. How does its kinetic energy at 4 rad compare with that at 0 rad?

Net torque decreases linearly from +4 N m at 0 rad through zero at 2 rad to -4 N m at 4 rad.
  1. A. It is 8 J smaller.
  2. B. It is zero regardless of initial energy.
  3. C. It is the same.
  4. D. It is 8 J larger.

Question 4 of 10

Which measurement is needed with a torque-versus-time graph to determine the work done by that torque in general?

  1. A. Only the rotor’s color
  2. B. Only the sign of its initial rotation
  3. C. No additional measurement; torque-time area is work
  4. D. The angular motion during the interval

Question 5 of 10

Two constant opposing torques act on a wheel turning at constant nonzero angular speed. Which statement is correct?

  1. A. Their works cancel over any angular displacement.
  2. B. Each does zero work.
  3. C. Both do positive work.
  4. D. Both do negative work.

Question 6 of 10

A brake removes 18 J as a rotor turns through 9 rad without reversing. What is the magnitude of its average torque over this angle?

  1. A. 27 N m
  2. B. 2 N m
  3. C. 162 N m
  4. D. 0.5 N m

Question 7 of 10

A rotor starts and ends with the same angular speed but reverses rotation between those instants. What is the net work done on it if its inertia is constant?

  1. A. Negative initial kinetic energy
  2. B. It cannot be determined even if both speeds are known.
  3. C. Zero
  4. D. Twice the initial kinetic energy

Question 8 of 10

A disk is driven by a force applied exactly through its fixed axle. The disk is already rotating. What work does that force do on its rotational motion?

  1. A. Positive, because the disk is moving
  2. B. Negative, because the force acts at the center
  3. C. An amount equal to force times angular displacement
  4. D. Zero, because its torque about the axle is zero

Question 9 of 10

A wheel turns through a complete revolution. A motor supplies positive torque during the first half and is disconnected during the second half; axle friction is negligible. Which graph correctly describes rotational kinetic energy versus angular position?

  1. A. It rises during the first half and is constant during the second half.
  2. B. It rises throughout the revolution.
  3. C. It is constant during the first half and falls during the second half.
  4. D. It immediately falls to zero when the motor is disconnected.

Question 10 of 10

A torque does +6 J while a wheel turns forward and -6 J while it returns to its starting angle. What is its total work for the full motion?

  1. A. 6 J
  2. B. 0 J
  3. C. 12 J
  4. D. -12 J