Competing Function Model Validation MCQ Practice

Question 1 of 10

A Pellegrin elevator’s height $H$ after $t$ seconds of a constant-speed climb shows nearly constant first differences.

$t$ $H$
$0$ $2$
$1$ $5$
$2$ $8$
$3$ $11$
  1. A. Exponential, because height is positive.
  2. B. Linear, because first differences are roughly constant.
  3. C. Quadratic, because the outputs increase.
  4. D. No model can be built without a residual table first.

Question 2 of 10

Kelvane yeast mass $M$ (g) after $t$ hours has successive ratios near $1.25$.

$t$ $M$
$0$ $8$
$1$ $10$
$2$ $12.5$
$3$ $15.625$
  1. A. $M(t)=8+2.5t$
  2. B. $M(t)=8\cdot(1.25)^t$
  3. C. $M(t)=-0.5t^2+8$
  4. D. $M(t)=8/t$ for $t>0$

Question 3 of 10

Context: a Cobalt fountain’s water height rises then falls symmetrically over a short cycle. Which model family matches the table?

$t$ $h$
$0$ $1$
$1$ $4$
$2$ $5$
$3$ $4$
$4$ $1$
  1. A. Exponential growth, because early heights increase.
  2. B. Linear through the endpoints only.
  3. C. Quadratic with a maximum near $t=2$.
  4. D. Constant $h=1$, matching the first and last rows only.

Question 4 of 10

Ridgeline rainfall totals $R$ (mm) after $d$ days of a steady storm show constant first differences of $6$.

$d$ $R$
$0$ $3$
$1$ $9$
$2$ $15$
$3$ $21$
  1. A. $R(d)=3\cdot 2^d$
  2. B. $R(d)=6d+3$
  3. C. $R(d)=3d^2$
  4. D. $R(d)=21-6d$

Question 5 of 10

Nettlewick engineers plot competing models for a cooling kiln: a line and an exponential decay curve against the data.

$t$ $T$
$0$ $200$
$1$ $100$
$2$ $50$
$3$ $25$
Cooling data with a steep downward line and an exponential decay curve matching the halved temperatures.
  1. A. Prefer the line, because cooling must be linear in every kiln.
  2. B. Prefer $T(t)=200\cdot(0.5)^t$, matching successive ratios of $1/2$.
  3. C. Prefer a quadratic opening upward, because temperatures stay positive.
  4. D. Neither model can be constructed from four points.

Question 6 of 10

A Lumenwick sensor’s reading $y$ versus $x$ has second differences near $+2$.

$x$ $y$
$0$ $1$
$1$ $2$
$2$ $5$
$3$ $10$
$4$ $17$
  1. A. Construct a linear model, because second differences relate only to residuals.
  2. B. Construct an exponential model, because $y$ is increasing.
  3. C. Construct a quadratic model, because second differences are roughly constant.
  4. D. Refuse all models until a calculator regression code is printed.

Question 7 of 10

A Harborline linear model predicts $y=14$ when $x=3$, but the observed value is $17$. Residual $=$ observed $-$ predicted. Which statement is correct?

  1. A. Residual $-3$; the model underestimates.
  2. B. Residual $+3$; the model overestimates.
  3. C. Residual $+3$; the model underestimates.
  4. D. Residual $0$; prediction equals observation whenever $x=3$.

Question 8 of 10

Residuals for a Cobalt exponential fit are listed.

$t$ Residual
$1$ $-0.4$
$2$ $0.1$
$3$ $-0.2$
$4$ $0.3$
  1. A. At $t=1$ the model underestimates, because the residual is negative.
  2. B. At $t=1$ the model overestimates, because the residual is negative.
  3. C. Alternating signs always prove the model is perfect.
  4. D. Residuals cannot be negative for exponential models.

Question 9 of 10

After a linear regression on Pellegrin wind-speed data, residuals versus $t$ form a clear arch (positive, then negative, then positive again). What validation conclusion follows?

$t$ Residual
$0$ $2.0$
$1$ $0.5$
$2$ $-1.5$
$3$ $0.4$
$4$ $1.8$
  1. A. Keep the line without question, because some residuals are positive.
  2. B. The patterned residual plot suggests trying a competing curved model.
  3. C. Conclude that wind speed cannot be modeled by any function.
  4. D. Replace residuals with absolute values and ignore signs.

Question 10 of 10

A Kelvane quadratic model predicts $9.2$ at $x=3$; the observed value is $8.5$. Which residual interpretation is right?

  1. A. Residual $+0.7$; underestimate.
  2. B. Residual $-0.7$; overestimate.
  3. C. Residual $-0.7$; underestimate.
  4. D. Residual $+0.7$; overestimate.