Function Model Selection and Assumption Articulation MCQ Practice

Question 1 of 10

A cargo conveyor adds packages at a steady count each minute. The table lists total packages $P$ after $t$ minutes.

$t$ $P$
$0$ $12$
$1$ $19$
$2$ $26$
$3$ $33$
$4$ $40$
  1. A. A quadratic model, because the totals keep increasing.
  2. B. A cubic model, because four intervals of data are shown.
  3. C. A piecewise model, because $P$ is never zero.
  4. D. A linear model, because first differences of $P$ are roughly constant.

Question 2 of 10

Equal-step water-depth readings $d$ (cm) are recorded as a tank fills.

$t$ $d$
$0$ $2$
$1$ $5$
$2$ $10$
$3$ $17$
$4$ $26$

First differences of $d$ are $3,5,7,9$. Which model type is most appropriate?

  1. A. Linear, because depth is increasing.
  2. B. Quadratic, because first differences change roughly linearly (second differences near $2$).
  3. C. Cubic, because first differences are not constant.
  4. D. Constant, because the input steps are equal.

Question 3 of 10

A landscape crew designs a rectangular patio whose length is $4$ ft more than its width $w$. Area $A$ as a function of $w$ is best modeled by which type?

  1. A. Linear, because length grows with $w$.
  2. B. Quadratic, because area is a product of two linear dimensions in $w$.
  3. C. Cubic, because three edges meet at a corner.
  4. D. Piecewise, because width and length use different units.

Question 4 of 10

A polymer sample’s measured mass $m$ (mg) at equal time steps has third differences that are essentially constant and nonzero, while second differences are not constant. Which polynomial degree is the best first choice?

  1. A. Degree $1$, because mass cannot be cubic in a lab.
  2. B. Degree $2$, because second differences appear in the table.
  3. C. Degree $3$, because constant third differences indicate a cubic model.
  4. D. Degree $4$, because four difference columns are always needed.

Question 5 of 10

The figure shows profit $y$ versus advertising spend $x$ for a small bakery. Which model type fits the graph’s shape best?

A downward-opening parabola through roughly (0,1), peaking near (3,5.5), and falling toward (6,1).
  1. A. Linear, because profit eventually falls.
  2. B. Quadratic, because the graph is a single smooth arch with one turning point.
  3. C. Cubic, because the graph crosses the horizontal axis twice.
  4. D. Piecewise linear, because left and right sides look like rays.

Question 6 of 10

A ramp’s height $h$ (ft) versus horizontal distance $x$ (ft) follows one constant slope on $[0,8]$ and a different constant slope on $(8,14]$. Which modeling choice is CED-aligned?

  1. A. A single linear function on $[0,14]$, because each piece is linear.
  2. B. A quadratic on $[0,14]$, because the slope changes once.
  3. C. A piecewise-linear function with different rules on $[0,8]$ and $(8,14]$.
  4. D. A cubic, because three endpoints $0$, $8$, and $14$ are named.

Question 7 of 10

A linear model $C=2.5t+40$ estimates the cost (dollars) of a community bike share after $t$ hours of use in one day. Which restriction is most appropriate?

  1. A. $t$ may be any real number, including negative hours.
  2. B. Restrict $t$ to $0\le t\le 24$ (or the shop’s open hours) and $C\ge 40$.
  3. C. Require $C$ to be an integer multiple of $2.5$ only.
  4. D. Force the domain to be empty because cost models are never linear.

Question 8 of 10

A quadratic volume model $V(r)=\pi r^2 h$ with fixed height $h>0$ is used for cylindrical grain bins. Which assumption is built into that choice?

  1. A. The bin’s cross-section stays a circle of radius $r$ and height stays $h$ as $r$ varies.
  2. B. Volume must be a cubic polynomial in $r$ for every container.
  3. C. Radius may be negative if the algebra allows it.
  4. D. The model requires $V$ to be periodic in $r$.

Question 9 of 10

A coach fits a cubic polynomial to five equally spaced sprint-time trials and then evaluates the cubic at a time far beyond the last trial. What limitation should be flagged?

  1. A. A degree-$3$ polynomial through four intervals of data can oscillate or trend unrealistically outside the sampled window.
  2. B. Cubic models are never allowed for time data.
  3. C. Extrapolation is safe because polynomials are defined for all real inputs.
  4. D. Five points always determine a unique linear model only.

Question 10 of 10

A piecewise ticket-price model charges one linear rate for the first $3$ hours of parking and another linear rate afterward. Which statement correctly addresses domain and continuity assumptions?

  1. A. The pieces may disagree at $t=3$; the model need not specify a value there.
  2. B. The domain should include only $t\ge 0$, and the modeler should decide whether the junction at $t=3$ is continuous or has a jump fee.
  3. C. Parking time must be restricted to integers because piecewise models forbid real inputs.
  4. D. Both pieces must use the same slope, or the model is invalid.