Thin-Film Interference MCQ Practice

Question 1 of 10

A light ray reflecting from a medium of higher index of refraction than the incident medium undergoes

  1. A. no phase change
  2. B. a $180^\circ$ phase change
  3. C. a frequency change to zero
  4. D. a permanent amplitude increase

Question 2 of 10

Reflection from a lower-index medium produces

  1. A. a $180^\circ$ phase change
  2. B. no phase change
  3. C. a $90^\circ$ phase change always
  4. D. absorption of all light

Question 3 of 10

When light is refracted across an interface, its phase

  1. A. always shifts by $180^\circ$
  2. B. does not change due to refraction alone
  3. C. becomes undefined
  4. D. must match the film thickness

Question 4 of 10

A soap film in air has $n=1.33$. For strong constructive reflection of vacuum wavelength $\lambda=560\,\mathrm{nm}$ at normal incidence in the thinnest non-zero case ($2nt=\lambda/2$), the thickness is

  1. A. $105\,\mathrm{nm}$
  2. B. $210\,\mathrm{nm}$
  3. C. $420\,\mathrm{nm}$
  4. D. $560\,\mathrm{nm}$

Question 5 of 10

An antireflection coating has $n_c=1.38$ on glass, with air above. For destructive interference of reflected $\lambda=550\,\mathrm{nm}$ light at normal incidence using the quarter-wave design, $t$ is

  1. A. $100\,\mathrm{nm}$
  2. B. $138\,\mathrm{nm}$
  3. C. $275\,\mathrm{nm}$
  4. D. $550\,\mathrm{nm}$

Question 6 of 10

Colors in soap bubbles and oil slicks arise mainly because

  1. A. pigments dissolve into the air
  2. B. film thickness variations change which wavelengths interfere constructively in reflection
  3. C. the Sun’s spectrum changes minute by minute
  4. D. polarization is impossible for light

Question 7 of 10

For AP Physics 2 quantitative thin-film analysis, incident light is assumed

  1. A. at grazing $89^\circ$ only
  2. B. normal to the surface
  3. C. unpolarized microwave only
  4. D. inside an opaque metal always

Question 8 of 10

The table lists interfaces. Which reflection has a $180^\circ$ phase shift?

Ray From Reflects at
1 air ($n=1.00$) water ($n=1.33$)
2 glass ($n=1.50$) air ($n=1.00$)
3 water air
  1. A. Ray 1 only
  2. B. Ray 2 only
  3. C. Rays 2 and 3
  4. D. None

Question 9 of 10

A simple antireflection coating is designed so that

  1. A. reflected rays constructively reinforce for the design wavelength
  2. B. reflected rays destructively interfere for the design wavelength
  3. C. no light is ever transmitted
  4. D. the coating index exceeds the substrate index

Question 10 of 10

For the standard antireflection stack air–coating–glass with $n_{\mathrm{air}}<n_c<n_g$, phase shifts occur at

  1. A. neither reflection
  2. B. both top and bottom reflections (each from higher $n$)
  3. C. only the glass–coating interface if $n_c>n_g$
  4. D. only refraction events