Reflection MCQ Practice

Question 1 of 10

A spherical wave expands from a point source in open air. Which geometric construction correctly represents a set of rays for that wave away from obstacles?

  1. A. Straight arrows drawn radially outward, each perpendicular to the spherical wavefronts
  2. B. Closed circles centered on the source, because rays must follow wavefronts
  3. C. Arrows tangent to the wavefronts, circulating around the source
  4. D. A single horizontal arrow only, because all light travels parallel

Question 2 of 10

An engineer uses ray optics to aim a laser across a 40 m hallway through an open 0.90 m doorway. Diffraction spreading is estimated to be millimeters. Is the ray model justified for centering the beam on a 5 cm target?

  1. A. Yes: millimeter-scale diffraction is negligible compared with the target size and doorway width.
  2. B. No: any doorway forces a full Fresnel analysis before aiming.
  3. C. No: rays cannot be used in air, only in vacuum.
  4. D. Yes only if the laser is incoherent.

Question 3 of 10

Compared with drawing many rays from an extended lamp filament, modeling a laboratory laser with one ray is usually better because

  1. A. the laser’s light is concentrated in a narrow, nearly unidirectional beam
  2. B. lasers emit no electromagnetic waves
  3. C. a laser beam never reflects or refracts
  4. D. one ray automatically includes interference fringes

Question 4 of 10

Which phenomenon is outside the intended use of geometric ray diagrams in AP Physics 2 Unit 13?

  1. A. Locating an image formed by a plane mirror
  2. B. Predicting the bright-fringe spacing of a double-slit pattern
  3. C. Tracing reflection from a concave spherical mirror
  4. D. Applying Snell’s law at a flat air–glass interface

Question 5 of 10

A student draws curved “rays” that follow the crests of a water-wave photograph. What error does that introduce relative to the geometric-optics definition of a ray?

  1. A. Rays should be drawn perpendicular to wavefronts (crests), not along them.
  2. B. Rays may never be drawn for any wave.
  3. C. Rays must always be circular arcs.
  4. D. Rays exist only inside glass, not in photographs.

Question 6 of 10

A ray strikes a plane mirror with $\theta_i=48^\circ$ from the normal. The angle between the incident and reflected rays is

  1. A. $48^\circ$
  2. B. $96^\circ$
  3. C. $42^\circ$
  4. D. $24^\circ$

Question 7 of 10

Identical beams hit two patches of the same metal: Patch A is optically flat; Patch B is grit-blasted rough. Far from the specular direction, which patch sends more light to a fixed detector, and why?

  1. A. Patch B, because varying normals produce diffuse reflection into many directions
  2. B. Patch A, because only smooth surfaces can reflect at all
  3. C. Neither, because metal never reflects visible light
  4. D. Patch A, because roughness always absorbs 100% of the beam

Question 8 of 10

For reflection from a surface, the normal is defined as

  1. A. the line perpendicular to the surface at the point of incidence
  2. B. the line parallel to the surface through the point of incidence
  3. C. the bisector of the incident ray only
  4. D. any line drawn from the light source to the surface

Question 9 of 10

A plane mirror rotates by $7.0^\circ$. A fixed incident laser ray reflects from the mirror. The reflected ray’s direction changes by approximately

  1. A. $3.5^\circ$
  2. B. $7.0^\circ$
  3. C. $14^\circ$
  4. D. $28^\circ$

Question 10 of 10

Which statement correctly contrasts specular and diffuse reflection?

  1. A. Specular: nearly unique outgoing direction from a smooth surface; diffuse: many outgoing directions from a rough surface.
  2. B. Specular occurs only underwater; diffuse occurs only in air.
  3. C. Diffuse reflection violates $\theta_i=\theta_r$ for every local normal.
  4. D. Specular reflection requires the incident angle to equal $90^\circ$.