Introduction to Optimization Problems MCQ Practice

Question 1 of 10

A farmer will enclose a rectangular pen against an existing barn wall using $80$ m of fencing for the other three sides. Which quantity is the natural objective to maximize?

  1. A. The amount of fencing used
  2. B. The area of the pen
  3. C. The length of the barn wall
  4. D. The perimeter of a square

Question 2 of 10

In the barn-and-fence problem with $80$ m of fencing for three sides, if $x$ is the side perpendicular to the barn and $y$ is the side parallel to the barn, which equation is the constraint?

  1. A. $2x+y=80$
  2. B. $xy=80$
  3. C. $x+y=80$
  4. D. $2x+2y=80$

Question 3 of 10

For that same pen, after writing $A=x(80-2x)$, which statement about the domain is correct?

  1. A. $x$ may be any real number
  2. B. $x\ge 80$
  3. C. $0<x<40$, because both $x$ and $y=80-2x$ must be positive
  4. D. $x>40$ only

Question 4 of 10

A company sells $x$ units of a product. Revenue is $R(x)$ and cost is $C(x)$. The quantity to maximize for profit is

  1. A. $R(x)$ alone
  2. B. $C(x)$ alone
  3. C. $R(x)+C(x)$
  4. D. $P(x)=R(x)-C(x)$

Question 5 of 10

A wire of length $L$ is cut into two pieces. One piece forms a square and the other forms a circle. The goal is to minimize total enclosed area. Which list correctly names objective, constraint, and a domain restriction?

  1. A. Objective: total area; constraint: the two pieces add to length $L$; domain: each piece length between $0$ and $L$
  2. B. Objective: length $L$; constraint: total area is fixed; domain: all real lengths
  3. C. Objective: the square's side; constraint: the circle's radius; domain: empty
  4. D. Objective: maximize $L$; constraint: none; domain: $L>100$

Question 6 of 10

The table summarizes an optimization setup. What is missing before one should differentiate?

Piece Expression
Objective (two variables) $A=xy$
Constraint $x+2y=30$
Domain intent $x>0$, $y>0$
  1. A. A calculator only
  2. B. An objective function of a single independent variable, obtained by using the constraint to eliminate the other variable
  3. C. A proof that no maximum exists
  4. D. A random guess for the answer

Question 7 of 10

A rectangular poster must have $24$ in$^2$ of printed area with $2$-inch margins on each side. Identifying the printed width and height as the constrained product, the objective typically maximized or minimized is

  1. A. the printed area, which is already fixed
  2. B. the margin width, which is already fixed
  3. C. the total poster area (or total paper used)
  4. D. the number of colors of ink

Question 8 of 10

Which statement best describes the role of the domain in an optimization setup?

  1. A. It lists the admissible values of the independent variable so endpoint and critical-point candidates can be compared later
  2. B. It replaces the need for a constraint equation
  3. C. It is optional if the objective looks simple
  4. D. It is always the entire real line for applied problems

Question 9 of 10

A light is to be placed on a wall so that illumination on a point on the floor is maximized. Before solving, which identification is correct?

  1. A. The objective is necessarily the wall height; there is no constraint
  2. B. The objective is illumination (or intensity) at the target point; geometry relating distance and angle is the constraint structure; the domain restricts feasible heights or angles
  3. C. The objective is to minimize the speed of light
  4. D. Only the derivative is needed; naming the objective is unnecessary

Question 10 of 10

In an open-top box made from a $12$ by $12$ square sheet by cutting equal squares of side $x$ from each corner, the constraint is built into the geometry. The objective function for volume is

  1. A. $V=12x$
  2. B. $V=x^2$
  3. C. $V=(12-x)^2 x$
  4. D. $V=(12-2x)^2 x$